scott
New Member
Posts: 6
|
Post by scott on Sept 21, 2010 15:42:38 GMT -5
My seat lock doesn't seem to be working. I can remove the seat without using the key. I can see the cable moving close to the barrel when I turn the lock, but nothing happens where the D part of the seat should be locking into the bike.
This isn't effecting the ride, but would be nice to be able to use the helmet locks.
Any suggestions?
|
|
|
Post by Jake on Sept 22, 2010 14:01:29 GMT -5
My seat lock doesn't seem to be working. I can remove the seat without using the key. I can see the cable moving close to the barrel when I turn the lock, but nothing happens where the D part of the seat should be locking into the bike. This isn't effecting the ride, but would be nice to be able to use the helmet locks. Any suggestions? If its down to corrosion Scott, then I can only suggest that you try WD40 oil or Plus Gas. But you may have to replace the lock. See also link below: growell.proboards.com/index.cgi?board=body&action=display&thread=1362
|
|
scott
New Member
Posts: 6
|
Post by scott on Sept 22, 2010 14:44:48 GMT -5
Thanks Jake, I'll try some WD40 tomorrow. But I if it is corrosion I think it must somewhere in the cable as the lock does move.
|
|