|
Post by jonsan on Sept 30, 2010 10:12:29 GMT -5
|
|
|
Post by outlaw on Sept 30, 2010 14:13:41 GMT -5
hi,i have emailed the guy and to fit them to the ntv you will have to drill the frame as the bars do not match the rear engine bolts, as they are for a bros which has a smaller frame, outlaw
|
|
|
Post by Jake on Oct 1, 2010 1:50:34 GMT -5
|
|
|
Post by jonsan on Oct 2, 2010 10:40:40 GMT -5
Sorry about that, looks like there are lots of differences apart from the aluminium frame and shaft drive. Just looked at a bros frame in my shed and compared it against my NTV the rear mount position must be different on the crankcases too, ie further back. However at least we now know the BROS engine bars won't fit the NTV. I wouldn't go for drilling the frame, probaby better to do a cut, extend and weld job on the bars to move the rear mount to the correct position, but to make this worthwhile, the Bros bars would have to be very cheap.
|
|
|
Post by outlaw on Oct 5, 2010 3:40:56 GMT -5
i had a look at some photo,s of the engine of a bros and the rear engine mount is closer to the rear of the crank case,s than the ntv. outlaw
|
|