Post by heyskull on Nov 11, 2012 7:53:25 GMT -5
Exhaust Desperately Wanted!!!!!
Well I thought if I remove the old exhaust (Motad) and plate it up because of the huge hole on the bottom that would be that!.
Well after trying to figure how they were attached to the down pipes (Yes there should be 2 clamps). I realised that the last numpty owner had welded them.
After grinding the welds off I managed to split them, only to have the whole thing fold in half!
So I am looking for a rear box and with funds so low it doesn't have to be pretty it just has to be solid and cheap.
It's a bit of a pain with these bikes as unlike other bikes you can't swap end cans around due to the fact it has two inlets!
Help please.
On another note what other model of bikes will fit!
Thanks
SC
Well I thought if I remove the old exhaust (Motad) and plate it up because of the huge hole on the bottom that would be that!.
Well after trying to figure how they were attached to the down pipes (Yes there should be 2 clamps). I realised that the last numpty owner had welded them.
After grinding the welds off I managed to split them, only to have the whole thing fold in half!
So I am looking for a rear box and with funds so low it doesn't have to be pretty it just has to be solid and cheap.
It's a bit of a pain with these bikes as unlike other bikes you can't swap end cans around due to the fact it has two inlets!
Help please.
On another note what other model of bikes will fit!
Thanks
SC
