|
Post by toshntv650 on Dec 9, 2013 17:56:22 GMT -5
Hi Guys,
Could any one confirm how many pilot screws are there on the carb. What i can see is one that can be adjusted without a problem on one side. And on the other it appear to be capped off? In the manual it says about drilling hole in the cap and pulling it out? would this be referring to the 2nd pilot screw?
Thanks for your help
|
|
|
Post by Jake on Dec 11, 2013 6:31:09 GMT -5
I can see reference to only one adjustable pilot screw in the Haynes manual (p 4.6). If the other one is blanked off then it's probably factory pre-set.... But, sometimes it’s useful to compare with the Hawk/Bros manual. Not sure if the carbs on the Hawk are the same as the NTV, but see below for more info: hawkworks.net/manual/4.html#4-7-pilot-screw-removalHope it helps.....
|
|