|
Post by gripper on Aug 3, 2011 9:56:57 GMT -5
There are two little studs on the inside of the left hand main frame spar. I presume these are to take the plastic retaining clips. The wiring loom on my bike runs along the right hand side of the cylinder heads towards the rear of the bike. Is that correct and if so what is retained by the two clips? Is there a diagram available that shows the routing/orientation of the various cables and wiring loom.
|
|
|
Post by Jake on Aug 3, 2011 13:40:53 GMT -5
..... Is there a diagram available that shows the routing/orientation of the various cables and wiring loom. The only diagram I could find was for the Hawk/Bros: Also check page 9.22 of the NTV/Revere manual: wbieniec.kis.p.lodz.pl/moto/ntv/manual/9.pdf
|
|
cyril
Full Member
Posts: 58
|
Post by cyril on Aug 4, 2011 14:43:59 GMT -5
Hi Gripper.
Just checked my bike. The studs are for the plastic quick release clips. The front one supports the coolant pipe to the expansion tank only. The rearmost one also supports the fuel pipe to the carburettors. The fuel pipe is in a stiffer sleeving. ( guess to give some heat protection).
I hope this helps. Chris
|
|
|
Post by gripper on Aug 4, 2011 16:26:31 GMT -5
Many thanks Jake and Chris
|
|