|
Post by timfevs on Jan 18, 2013 11:15:49 GMT -5
Hi, I have a Revere 600 k model. I decided to remove the fairing ,because I think it looks better naked, unfortunately the wiring at the front is a real mess. Also the headlight bracket was missing. Picked one up from David Silver but there is something else missing to attach it to the bike. I was wondering if there was anyone who could email me some close up pics behind the headlight so I can see how its assembled. Any help is much appreciated. Also I have a scuffed but perfectly useable full fairing with brackets up for grabs.
|
|
gills
New Member
Posts: 21
|
Post by gills on Jan 18, 2013 14:35:57 GMT -5
|
|
|
Post by timfevs on Jan 19, 2013 10:35:54 GMT -5
hi thanks for the reply gills. I bought the bracket mentioned no.20. It just seems there is something missing off the yokes, to attach it too. Might be me not seeing it right because I bought the bike with the fairing already on. There is 2 tapped holes on the bottom yoke is there supposed to be a smaller bracket attached to that? Thanks in advance for any help. Tim
|
|
gills
New Member
Posts: 21
|
Post by gills on Jan 19, 2013 13:03:00 GMT -5
I've just been out and taken a few photos (pardon the snow!). The top of the bracket appears to slot into the bottom of the top yoke - the photos taken up from behind the fork: It looks like the bottom slots into a tab attached to the back of the horn bracket. This is taken looking up at the bottom of the bottom yoke from the mudguard: This schematic appears to show the tabs on the horn bracket (no.7): Hope this helps.
|
|
|
Post by timfevs on Jan 19, 2013 16:35:40 GMT -5
Hi gills. Thanks again. I don't have the horn bracket thats why it doesn't look right. the pics aren't showing unfortunately but I kind of understand where it goes. I will try to source a horn bracket. Thanks for your help.
|
|